Retired - Jungle Lady Bracelet

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. To make this bracelet, you will be using the same technique as pearl knotting, just on a larger scale.
2. Cut about 2 feet of micro-fiber suede cord.
3. Take your fold over crimping pliers and at the end of one side of the cord, attach a fold over cord end.
4. Now you can begin your knotting. Tie one over hand knot as close as you can to the cord end.
5. Thread on one wood bead, tie another knot. Repeat this step 8 more times.
6. Snip the micro suede and attach another fold over cord end, as you did before.
7. Open one jump ring, loop it through the hole of the cord end. Close the jump ring.
8. Open another jump ring and loop it through the other cord end and the loop on the lobster clasp. Close the jump ring.

• BWD-0301 - Round Wood Beads Dark Brown And Black Zebra Stripe 18mm (4)
  Project uses 9 pieces. You will need 3 packages.


• FJR-5000 - Antiqued Brass Open Jump Rings 5mm 19 Gauge (50)
  Project uses 2 pieces. You will need 1 package.


• FCL-4711 - Antiqued Brass Curved Lobster Clasps 12mm (10)
  Project uses 1 piece. You will need 1 package.


• FCR-1445 - Antiqued Brass Foldover 3mm Cord Ends For Ribbon
  Project uses 2 pieces. You will need 1 package.


• XCR-43102 - Beadsmith Medium Brown Faux Leather Suede Beading Cord 9Ft (3 Yd) Spool
  Project uses 24 inches. You will need 1 package.

• XTL-5260 - Beadsmith Fold Over Crimping Pliers For Leather & Suede Findings
• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex
• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose