Retired - Infinite Blue Regaliz Bracelet

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Take your eight inches of rubber cord and slide on the infinity slider.
2. Take one end of the cord and place it into the cord end, without glue. Repeat on the other side. This will help you with sizing. If you need to trim the cord, use the cord cutter tool for Regaliz to trim a little bit at a time.
3. Once you have your size, separate the magnetic clasp. Place a dab of super new glue into the well of one side of the clasp. Place the cord end into the clasp. Hold in place for a few moments. Repeat this on the other side of the clasp.
4. Note: make sure to leave the clasp un done while it dries completely over night before clasping together to wear.
5. All done!

• CHX-1108 - Regaliz Corduroy Rubber Cord 10x6.5mm - Blue (Sold By The Inch)
  Project uses 8 Inches. You will need 8 packages.


• FCL-1605 - Antiqued Silver Plated Curved Magnetic Clasp/Cord Ends For Regaliz 10mm Rubber Cord
  Project uses 1 piece. You will need 1 package.


• BMB-9944 - Antiqued Silver Infinity Symbol Bracelet Slider For Regaliz 10mm Rubber Cord - 1 Piece
  Project uses 1 piece. You will need 1 package.


• XTL-1059 - Eurotool Super New Glue - Heavy Duty Adhesive - 3 Gram Bottle
  Project uses 1 piece. You will need 1 package.

• XTL-5500 - Cord Cutter Tool For Regaliz Cord 3 Inches Long