Yosemite Bracelet

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Cut your memory wire so that you have 6 continual coils (loops).
2. Finish one end of the cut memory wire with a simple loop. To see how to do this, please watch the video: How to Finish Memory Wire Ends.
3. String onto your memory wire: 1/2 the strand of 4mm gemstone cube beads, the strand of 8.5mm pale blue amazonite beads - but leave 2 beads unstrung, and the other half of your 4mm gemstone beads. Create a simple loop (as seen in the video) after your last bead and cut off excess memory wire.
4. Place onto a head pin one 8.5mm pale blue amazonite bead. Create a simple wire loop after the bead and snip off excess wire. Repeat this step with another head pin and bead.
5. Open the simple wire loops on the dangles above (the same way you would open a jump ring) and connect one to each of the loops on the bracelet. Close the loops back up.
6. All done!

• SPAZ-28 - Pale Aqua Green Amazonite 8mm Round Beads /15.5 Inch
  Project uses 1 strand. You will need 1 package.


• SPMX-44 - Gemstone Cube Bead Mix 4 x 4mm Beads /15.5 Inch Strand
  Project uses 1 strand. You will need 1 package.


• WXM-038 - Gun Metal Grey Plated Stainless Steel Bracelet Memory Wire 12 Loops
  Project uses 6 coils. You will need 1 package.


• FHP-6309 - Gun Metal Plated Head Pins 2 Inches/21 Gauge (50)
  Project uses 2 pieces. You will need 1 package.

• XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers
• XTL-5612 - Beadalon Memory Wire Shears Cutting Pliers -Strong & Easy
• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose