Retired - Dream Angel Earrings

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Take one eye pin, thread on one coin pearl. Make a simple wire loop.
2. Open the loop of the earring hook, the same way you would a jump ring and attach it to the eye pin with the pearl on it. Close the loop.
3. Open the other end of the eye pin and attach it to the jump ring that is attached to the Wing charm. Close the loop.
4. All done!

• PND-10562 - Silver Plated and Enameled Charm, Angel Wing (Right) 24x9x3mm, 1 Piece, White
  Project uses 1 piece. You will need 1 package.


• PND-10499 - Silver Plated and Enameled Charm, Angel Wing (Left) 24x9x3mm, 1 Piece, White
  Project uses 1 piece. You will need 1 package.


• SWP-7001 - Austrian Crystal, 5860 Coin Faux Pearl Beads 10mm, 6 Pieces, White
  Project uses 2 pieces. You will need 1 package.


• FEA-3015 - Silver Plated Fishhooks Earring Hooks (50)
  Project uses 2 pieces. You will need 1 package.


• FHP-6266 - Silver Plated Open Eye Pins 22 Gauge 1.5 Inch (x50)
  Project uses 2 pieces. You will need 1 package.

• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
• XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers
• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex