Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available,
may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND
OTHER SUPPLIES sections for current availability.
In addition to the materials listed, you will also need some paper towels to complete this project. These materials will make an 18 inch necklace. For a longer or shorter necklace, you can purchase a finished chain necklace of a different length.
- To begin, please watch our video on how to use Vintaj patinas. Set out your TierraCast floral pendant on your work surface.
- Pour out a little bit of the jade green patina onto your work surface. Using a dry paintbrush, dab the patina into the etched leaves of the floral charm. Quickly wipe away the excess patina with a paper towel. Wait a few minutes for the patina to dry.
- Pour out a little bit of the pink petalite patina onto your work surface. Using another dry paintbrush, dab the patina into the etched flower bloom on the floral charm. Quickly blot away the excess patina with a paper towel. Wait about an hour for the patina all over the piece to completely dry.
- Take your Vintaj relief block and buff the front of the pendant to remove some of the antiqued finish and reveal the metal highlights of the pendant.
- Using pliers, open a jump ring. Slide it through the hole at the top of the floral pendant, and also slide it onto your finished chain necklace. Close the jump ring.
- Enjoy your necklace!
WHAT YOU'LL NEED: (scroll down for purchase options)
- PND-0268 - TierraCast Charm, Flora Round 22mm, 1 Piece, Brass Oxide Finish
Project uses 1 piece. You will need 1 package.
- XTL-9065 - Vintaj Patina Opaque Permanent Ink - Jade Green - 0.5 Ounce Bottle
Project uses 1 piece. You will need 1 package.
- XTL-1131 - Vintaj Patina, Opaque Permanent Ink For Metal, 0.5 Ounce, Petalite
Project uses 1 piece. You will need 1 package.
- FJR-5471 - Antiqued Brass Open Jump Rings 5mm 20 Gauge (x100)
Project uses 1 piece. You will need 1 package.
- AXC-98943 - Antiqued Brass Fine Rolo Chain Necklace - 2mm Diameter Links 18 Inches Long
Project uses 1 piece. You will need 1 package.
RECOMMENDED TOOLS:- XTL-880 - ICE Resin, Angled Paint Brushes for ICED Enamels & Paper Sealant, 6 Pack
- XTL-2222 - Vintaj Metal Relief Block For Filing, Buffing & Sanding
- XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
- XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers