Retired - My Love Necklace

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Take one eye pin and string on one gold bead, one heart, and one gold bead. Make a simple wire loop.
2. Cut the chain into two equal pieces measuring 9 inches each.
3. Take one length of chain and attach the end to the eye pin by opening the loop, same as you would a jump ring, and closing it. Repeat this for the other length of chain on the other side of the eye pin.
4. To the end of each piece of chain, attach one jump ring. To the right piece of chain, attach one lobster clasp to that jump ring.
5. All done!

• BDLL-6061 - Beadelle Crystal Pave 12mm Heart Bead Horizontal Hole Silver Plated / Crystal
  Project uses 1 piece. You will need 1 package.


• FHP-6220 - 22K Gold Plated Open Eye Pins 21 Gauge 2 Inches (x50)
  Project uses 1 piece. You will need 1 package.


• BMB-5061 - 22K Gold Plated 2.5mm Round Metal Beads (100)
  Project uses 2 pieces. You will need 1 package.


• FJR-3914 - 22K Gold Plated Open Jump Rings 4mm 20 Gauge 22k Gold Plated (100)
  Project uses 2 pieces. You will need 1 package.


• FCL-4720 - 22K Gold Plated Curved Lobster Clasps 10mm (6)
  Project uses 1 piece. You will need 1 package.


• CHA-99970 - Bright 22K Gold Plated Long And Short Chain 2.5x4.5mm - Bulk By The Foot
  Project uses 18 Inches. You will need 2 packages.

• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex
• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
• XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers