Retired - Los Feliz Necklace Trio

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Open a 4mm jump ring. Slide it through the loop at the top of 1 Austrian crystal crystal channel charm, and slide the jump ring onto the 16 inch fine ball chain necklace. Close the jump ring.
2. Take your 18 inch cable chain necklace and find the midpoint. Cut the chain link in the middle with flush cutters.
3. Open a jump ring and slide it through the hole on one side of the chevron connector link. Also slide it through the last link of chain on one side of the center, as shown in this video. Repeat this step to connect the other side of the chevron to the other side of the necklace.
4. Take your 24 inch rolo chain necklace and find the midpoint. Cut the chain link in the middle with flush cutters. Then measure and cut off 1/2 inch of chain on either side of the split.
5. Using flush cutters, cut 3 inches of triangle pennant charm chain (cut the jump ring between triangle charms).
6. Open a jump ring. Slide it through the hole on one side of the first triangle in the 3 inch length of chain, and also slide it through the last link of chain on one side of the center of the rolo chain. Repeat this step to connect the other side of the triangle chain to the other side of the necklace.
7. Wear your necklaces in layers: the fine ball chain on top, the cable chain with the chevron in the middle, and the long rolo chain below. Enjoy!

• AXC-038 - Finished Ball Chain Necklace, Fine 1.2mm Links with Spring Ring Clasp, 16 Inches, Silver Plated
  Project uses 1 piece. You will need 1 package.


• AXC-027 - Finished Cable Chain Necklace, Fine 2x1.8mm Links with Spring Ring Clasp, 18 Inches, Silver Plated
  Project uses 1 piece. You will need 1 package.


• AXC-034 - Finished Rolo Chain Necklace, 1.7mm Round Links with Spring Ring Clasp, 24 Inches, Silver Plated
  Project uses 1 piece. You will need 1 package.


• SWFA-1023 - Austrian crystal Gold Plated Channel Crystal Charm Siam 7mm (8)
  Project uses 1 piece. You will need 1 package.


• PND-12031 - GenY Link, Chevron 25x9mm, 1 Piece, Forever Silver
  Project uses 1 piece. You will need 1 package.


• CHA-0183 - Bulk Chain, with 6.5mm Triangle Pennant Connector Links, Sold By The Foot, Gold Tone Brass
  Project uses 3 inches. You will need 1 package.


• FJR-5454 - Silver Plated Open Jump Rings 4mm 22 Gauge (50)
  Project uses 5 pieces. You will need 1 package.

• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
• XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers
• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex