Retired - Wrapped Cabochette Necklace

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Before you begin, watch the instructional video: How to Wire Wrap a Briolette. This video will demonstrate two ways to wire wrap a briolette. We are going to apply the second method to our Cabochette pendant.
2. Using 24 gauge silver plated non tarnish craft wire, start with 12 - 18" and wrap a 20mm jet crystal Cabochette pendant using the second method shown in the video.
3. Trim the excess wire and tuck in the wire ends to the back of the pendant.
4. Open the clasp on the 18" silver plated box chain necklace. Remove the jump ring from the end and slide the chain through the loop on your pendant. Replace the jump ring.

• AXC-98905 - Silver Plated Venetian Box Chain Necklace With Clasp - 18 Inches
  Project uses 1 piece. You will need 1 package.


• WCR-2430 - Artistic Wire, Silver Plated Craft Wire 24 Gauge Thick, 10 Yard Spool, Tarnish Resistant Silver
  Project uses 18 inches. You will need 1 package.


• SWBB-4437 - Austrian Crystal, 6026 Cabochette Pendant 20mm, 1 Piece, Jet
  Project uses 1 piece. You will need 1 package.

• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
• XTL-0074 - Eurotool Nylon Jaw Pliers Chain Nose- For Scratch-Free Wire Work
• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex
• XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers