Retired - Star Dust Choker

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Cut two lengths of black leather cord, 14.5 inches each.
2. Cut two lengths of brown leather cord, 14.5 inches each.
3. Line up the four strands at the ends and alternate the colors: black, brown, black, brown and place them flat inside one ribbon crimp. Crimp the ribbon crimp around one set of cord ends.
4. Slide on the star slider bead.
5. Repeat the above process to add a ribbon crimp to the other side of the cords.
6. Open one jump ring and attach it to one ribbon crimp and one end of the clasp. Close the jump ring. Repeat on the other side and you're all done!

• CHY-2002 - Genuine Leather Cord, Round 2mm, By the Yard, Black
  Project uses 29 Inches. You will need 1 package.


• CHY-2003 - Genuine Leather Cord, Round 2mm, By the Yard, Chocolate
  Project uses 29 Inches. You will need 1 package.


• BMB-10011 - Antiqued Silver Plated Double Sided Star Slider For Regaliz 10mm Flat Cork Cord
  Project uses 1 piece. You will need 1 package.


• FCL-6808 - Silver Plated Magnetic Clasps 6 x 4.5mm (4 Sets)
  Project uses 1 piece. You will need 1 package.


• FJR-3920 - Silver Plated Open Jump Rings Oval 21 Gauge 3x4mm (50)
  Project uses 2 pieces. You will need 1 package.


• FCR-1420 - Silver Plated Ribbon Pinch Crimps Cord Ends 10mm or 3/8 Inch (20)
  Project uses 2 pieces. You will need 1 package.

• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
• XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers
• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex