Retired - Silver Noodle Bracelet

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Cut a 10-inch length of Satin Silver 0.19" Beadalon beading wire.
2. String one crimp bead, then one wire guard. Tuck the end of the wire back into the crimp bead and crimp it. Cover the crimp bead with a crimp bead cover.
3. String one noodle bead, one 3mm Sterling Silver bead, one turquoise bead and another 3mm bead. Repeat two more times. Then add the last noodle bead.
4. String on one more crimp bead and one more wire guard. Pass the wire back through the crimp bead and crimp it. Be careful not to lose the crimp bead inside the noodle bead! You are going to be putting a crimp bead cover over the crimp bead, so you can leave up to a millimeter between the crimp bead and the end of the noodle bead.
5. Trim the wire. Cover the crimp bead with a crimp bead cover.
6. Use a jump ring at each end of the bracelet to connect each part of the toggle clasp.

• BMB-01231 - Sterling Silver Seamless Round Beads 3mm (20)
  Project uses 6 pieces. You will need 1 package.


• FJR-03046 - Sterling Silver Open Jump Rings 4mm 21 Gauge (20)
  Project uses 2 pieces. You will need 1 package.


• FCL-3085 - Sterling Silver Diamond Square Toggle Clasp 13mm
  Project uses 1 piece. You will need 1 package.


• FCR-01122 - Sterling Silver Crimp Beads 2 x 2mm (20)
  Project uses 2 pieces. You will need 1 package.


• FCR-01000 - Sterling Silver Crimp Bead Covers 3mm (20)
  Project uses 2 pieces. You will need 1 package.