Retired - Periwinkle Cluster Ring

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Onto ten headpins, thread an 11/0 seed bead and a 6/0 seed bead. Make a simple loop on the end of each headpin and trim off excess wire.
2. Onto twenty headpins, thread an 11/0 seed bead and a light blue Czech glass rondelle. Make a simple loop on the end of each headpin and trim off excess wire.
3. Open each of the loops, the same way you would open a jump ring.
4. Onto each of the ten loops on the ring, thread two of the glass bead dangles and one seed bead dangle.
5. Close each of the dangles loops.

• JR-1052 - Copper Plated Ten-Loop Beading Rings Adjustable (x4)
  Project uses 1 piece. You will need 1 package.


• FHP-1038 - Head Pins, 1.5 Inches Long and 24 Gauge Thick, 50 Pieces, Copper
  Project uses 30 pieces. You will need 1 package.


• BCS-1162 - Czech Seed Beads Mix 11/0 Copper Supra Metallic (1 Hank)
  Project uses 30 pieces. You will need 1 package.


• BCS-6162 - Czech Seed Beads 6/0 Light Copper Supra Metallic (1 Ounce)
  Project uses 10 pieces. You will need 1 package.


• BCP-4650 - Czech Pressed Glass Beads 6 x 2mm Rondelle Spacers Light Blue Opal (25)
  Project uses 20 pieces. You will need 1 package.