Retired - Night Owl Bracelet

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Begin by finding the center point of your cuff bracelet.
2. Turn your owl stamping over and trace a line of glue onto the outer edges of your stamping. Since your stamping is hollow, be sure to add as much glue as you need around the edges to ensure a sturdy application. Flip it over, and place it onto the center portion of your cuff bracelet. Press down gently and hold in place for a few seconds, allowing it to glue onto the cuff. Set your bracelet cuff aside to dry with the owl stamping facing up.
3. Next, take a bezel cup and add a dab of glue onto the center. Take your black cabochon, flip it over (with the flat side down), and place it into the bezel cup. Press down gently, gluing the cabochon into place.
4. Repeat this step again with your second bezel cup and cabochon. Wait a few minutes for both bezel cups to dry.
5. Then, add a dab of glue onto the back of your first bezel cup. Gently glue it onto your bracelet cuff, to the right side of your owl stamping.
6. Take your other bezel cup, add your glue to the back, and glue it onto the left side of your bracelet.
7. Your bracelet is done.

• SPCB-1302 - Glass Cabochons - 13mm Round - 'Jet Black' (4 Pieces)
  Project uses 2 pieces. You will need 1 package.


• PND-10000 - Antiqued Brass Owl Face Stamping 24.5x20mm (1)
  Project uses 1 piece. You will need 1 package.


• JB-2570 - Solid Brass Flat Cuff Bracelet Base 12.7mm (0.5 Inch) Wide (1 Piece)
  Project uses 1 piece. You will need 1 package.


• PND-6764 - Nunn Design Antiqued 24K Gold Plated Brass Round Bezel Cup Pendant 13mm (2)
  Project uses 2 pieces. You will need 1 package.


• XTL-1054 - E6000 Industrial Strength Glue Adhesive (0.18 fl oz)
  Project uses 1 piece. You will need 1 package.