Retired - Gold and Red Heirloom Ornament

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Onto a eyepin thread a daisy spacer, a 12mm open leaf bead cap, a 28mm glass bead, another 12mm open leaf bead cap, and finally another daisy spacer.
2. Make a simple loop at the end, and trim off excess wire.
3. Thread two additional eyepins with the following: a 7mm bead cap, a glass drop bead, and a 3.5mm cone flower bead cap. Create a simple loop at the opposite end of each and trim off excess wire.
4. Open the loop at the bottom of each drop bead and thread each loop through the loops at either end of the large glass bead. Close the loops once again.
5. Open the loop at the narrow end of one of the drop beads and thread it through the loop on the bell bead. Close the loop again.

• BGL-1942 -
  Project uses 1 piece. You will need 1 package.


• BMB-6454 - 22K Gold Plated Open Petal Flower Bead Caps 7mm (50)
  Project uses 2 pieces. You will need 1 package.


• BMB-6460 - 22K Gold Plated Cone Flower Bead Caps 6mm x 3.5mm (50)
  Project uses 2 pieces. You will need 1 package.


• BMB-6466 - 22K Gold Plated Filigree Open Leaf Bead Caps 12mm (12)
  Project uses 2 pieces. You will need 1 package.


• BMB-3219 - TierraCast Fine Bright 22K Gold Plated Pewter Daisy Spacer Beads 4mm (50)
  Project uses 2 pieces. You will need 1 package.


• BMB-5197 - Gold Color Steel Hollow Jingle Clapper Bell Beads 6mm (100)
  Project uses 1 piece. You will need 1 package.


• FHP-6220 - 22K Gold Plated Open Eye Pins 21 Gauge 2 Inches (x50)
  Project uses 3 pieces. You will need 1 package.