Retired - Mackenzie Bracelet

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Cut a length of cord 6 feet long.
2. 18 inches from one end, make a fold so that you have 18 inches on one side and 4 1/2 feet on the other side.
3. Tie an overhand knot, creating a loop.
4. Place the loop in the Mini Macrame Board, and place the short end of the cord into the bottom notch.
5. To the longer end of the cord, place a small piece of tape on the end to create a "needle" to thread on the jump rings.
6. Thread on the closed jump rings to the longer cord and tie a loose overhand knot to the end to keep them from slipping off.
7. For this next step please watch the video: How to Use Closed Jump Rings in Macrame Half Hitch Spiral Knots.
8. You will knot until you have 6 1/2 inches of knotting.
9. When you have your desired length, put both cords together and make an overhand knot, tying both ends together. Move about a 1/2 inch from the knot and snip off the excess cord.
10. All done!

• XCR-4488 - Waxed Cotton Cord, 2mm Round, 4 Meters / 13.1 Feet, Orange
  Project uses 6 Feet. You will need 1 package.


• FJR-4021 - 22K Gold Plated Closed Jump Rings 4mm 20 Gauge (20)
  Project uses 60 pieces. You will need 3 packages.

• XTL-5700 - Fiskars 5 Precision Tip Scissors - Super Sharp
• XTL-6120 - BeadSmith Mini Macrame Board For Braiding 9x6 Inches