Retired - Lucky Ladybug Earrings

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Cut the head off of an antique copper head pin. Create a simple wire loop at the end that you cut the head off of.
2. Measure and cut 3" of chain.
3. Thread the chain through the hole in the Golem pendant. Pull the chain so that the pendant is in the middle and the chain is not twisted.
4. Open the simple wire loop that you made in the first step and link onto it both ends of your chain from the previous steps. Close the loop.
5. Place a Czech glass 5mm round melon bead onto the wire that is sticking up from the chains/pendant. Create a simple wire loop right after the bead. Trim off excess with flush cutters.
6. Open the loop at the base of your earring hook. Link onto this loop the simple wire loop you made in the last step. Close the earring loop back up.
7. All done! Enjoy your pretty new pair of earrings.

• FEA-3018 - Genuine Antiqued Copper Fish Hook Earring Hooks 16mm (24)
  Project uses 2 pieces. You will need 1 package.


• BCP-1164 - Czech Pressed Glass - Round Melon Beads 5mm 'Opaque Olive/Marbled Gold' (50)
  Project uses 2 pieces. You will need 1 package.


• FHP-1052 - Genuine Antiqued Copper Head Pins 24 Gauge 2 Inches (24)
  Project uses 2 pieces. You will need 1 package.


• BWC-553 - Golem Design Studio Ceramic Pendant, 19mm Glazed Disc Ladybug, 2 Pieces, Green/Red
  Project uses 2 pieces. You will need 1 package.


• CHA-9815 - Nunn Design Antiqued Copper Plated Oval Cable Chain 3mm By The Ft
  Project uses 1 foot. You will need 1 package.

• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex
• XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers