Retired - Infinite Night Necklace

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Begin by cutting two lengths of chain 10 inches each. When you cut the chain, you should have one ball link with both jump rings attached at the beginning of the chain and at the other end cut off the last link before the ball so you have a length of chain without the ball. You will need both lengths of chain to be the same.
2. Take one length of chain with the chain at the end (not the ball), and string it through the opening on one side of the infinity link.
3. Open one jump ring and attach the end of this chain to the jump ring attached to the adjacent ball link of this chain. Close the jump ring. Repeat the above two steps on the other side of the infinity link.
4. Move to the end of the chain and open one jump ring. Attach it to the last jump ring in the chain. Close the jump ring.
5. Move to the other end of the chain and open one jump ring. Attach it to the last jump ring in the chain and to one lobster clasp. Close the jump ring.
6. All done!

• CHA-0451 - Gun Metal Plated Bulk Chain, Fine 2x1.5mm Cable Links with 2mm Ball, Sold By The Foot
  Project uses 20 Inches. You will need 2 packages.


• SWCR-6250 - Austrian Crystal, 6792 Infinity Pendant 18mm, 1 Piece, Crystal Metallic Lt Gold 2X
  Project uses 1 piece. You will need 1 package.


• FJR-5453 - Gun Metal Plated Open Jump Rings 4mm 22 Gauge (50)
  Project uses 4 pieces. You will need 1 package.


• FCL-2415 - Gun Metal Plated Curved Lobster Clasps 12mm (6)
  Project uses 1 piece. You will need 1 package.

• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex
• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
• XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers