Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
By following the instructions below you will make one earring. Repeat all instructions to make the second earring.
- Begin by stringing one bicone onto one head pin. Make a wrapped wire loop. Set aside. Repeat twice more.
- Open one jump ring, attach it to one of the wrapped wire loop dangles and attach it to the acetate hoop. Close the jump ring. Repeat with the other two dangles.
- Open another jump ring and attach it to the loop of the earring post and to the acetate hoop. Close the jump ring. Use the bullet earring back to wear your beautiful earrings.
WHAT YOU'LL NEED: (scroll down for purchase options)
- FCO-3333 - Zola Elements Resin Connector Link, Garden Party Circle 24mm, 2 Pieces, Multi-Colored
Project uses 2 pieces. You will need 1 package.
- PRES-5328-ROS6 - PRESTIGE Crystal, #5328 Bicone Bead 6mm, Rose Shimmer (1 Piece)
Project uses 6 pieces. You will need 6 packages.
- FJR-5465 - 22K Gold Plated Open Jump Rings 6mm 21 Gauge (50)
Project uses 8 pieces. You will need 1 package.
- FHP-5221 - 22K Gold Plated Head Pins - 22 Gauge, 2 Inches (X50)
Project uses 6 pieces. You will need 1 package.
- FEA-1526 - TierraCast 22K Gold Plated Pewter Stud Post Earrings Hammered 13.5mm 1 Pair
Project uses 1 Pair. You will need 1 package.
- FEA-1012 - Bullet Clutch Earring Backs, Hypo Allergenic 5.5x5mm, 50 Pcs, Gold Tone
Project uses 2 pieces. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5600 - Sharp Flush Cutter Pliers - For Cutting Beading Wire, 1 Piece
- XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
- XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers