Retired - Flutter By Necklace

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. To create the sense of movement in this necklace, you must gently (with emphasis on the word "gently"!) bend each of the butterflies, each one to a greater degree than the last. to bend them, line the center up with a sharp edge of a table. Gently press one wing down until it reaches the desired angle, turn the butterfly so that the other wing protrudes off of the edge of the table and repeat. Bend each butterfly a little more than the last to create the desired effect. The bottom butterfly, the dark blue one, remains flat.
2. The order of color should be as follows, from bottom butterfly to top:
3. dark blue
4. light blue
5. green
6. yellow
7. orange
8. red.
9. Stack all of your butterflies in this order. Open your jump ring and thread it through all of the butterfly loops. Close jump ring again.
10. Thread your chain through the jump ring and your necklace is ready to wear.

• PND-00305 -
  Project uses 1 piece. You will need 1 package.


• PND-00310 -
  Project uses 1 piece. You will need 1 package.


• PND-00308 -
  Project uses 1 piece. You will need 1 package.


• AXC-98905 - Silver Plated Venetian Box Chain Necklace With Clasp - 18 Inches
  Project uses 1 piece. You will need 1 package.


• FJR-03089 - Sterling Silver Open Jump Rings 8mm 18 Gauge Heavy (10)
  Project uses 1 piece. You will need 1 package.