Black Bullion Bracelet

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Begin by identifing the centermost link of your 13 inch section of curb chain, and note where the seam on the link is located.
2. Use two pairs of sturdy flat or chain nose pliers to grip the center link on either side of the seam. Open the link the same way you would open a jump ring to separate the two lengths of chain you will use for your project.
3. Please watch our video: How to Make a Cross Style Chain Woven Bracelet. In this video, you will see from start to finish how to create this bracelet using 3mm faux leather and thick flattened curb chain. You will also see how to tie off the cord and attach a clasp.

• FCL-7138 - TierraCast 22K Gold Plated Lead-Free Pewter 3/4 Inch Anna's Toggle Clasp (1)
  Project uses 1 piece. You will need 1 package.


• CHX-08014 - Gold Plated Bulk Chain, Heavy Flattened Curb Links 9.5x12.5mm, 1 Inch, Bright Gold
  Project uses 13 pieces. You will need 13 inches.


• FJR-5210 - 22K Gold Plated Open Jump Rings 10mm 18 Gauge (50)
  Project uses 2 pieces. You will need 1 package.


• XCR-43100 - Beadsmith Black Faux Leather Suede Beading Cord 9Ft (3 Yd) Spool
  Project uses 5 feet. You will need 1 package.


• XTL-1001 - G S Hypo Cement Precise Applicator Essential!
  Project uses 1 piece. You will need 1 package.

• XTL-4012 - Beadalon Tying Station Tool, for Shamballa and Wrapped Bracelets, 1 Piece
• XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers
• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex