Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
This necklace measures approximately 20 inches. To modify the length, simply adjust the number of beads strung respectively.
- Begin by cutting off 28 inches of beading wire. Place a bead stopper about 2 inches from one end.
- String on the beads in the following order: one silver rectangle bead, one 6mm white jade bead. Repeat 8 times. Then string one silver rectangle bead, one puff coin, and one silver rectangle bead. Then string on three amethyst chips and one silver rectangle bead. Repeat 12 times. Then string on one puff coin and one silver rectangle bead. String on one 6mm white jade bead and one silver rectangle bead. Repeat 8 times.
- String on one magical crimp in silver. Thread the wire up through one wire protector and over. Before stringing the wire back through the crimp tube, string onto the bar end of the toggle clasp to the wire protector. Once the wire is back through the crimp tube. Pull snug and using the magical crimping pliers crimp the crimp tube. Trim any excess wire.
- Remove the bead stopper and repeat the above process on the other side. Note that for the square end of the toggle you may need widen the opening of the wire protector a bit to accommodate the clasp. You can do this by prying it open with tip of your chain nose pliers.
WHAT YOU'LL NEED: (scroll down for purchase options)
- SPAM-901 - Gemstone Beads, Amethyst, Chips 8-15mm, 15.5 Inch Strand
Project uses 39 pieces. You will need 1 package.
- SPJD-46 - White Jade Serpentine 6mm Round Beads (15.5 In. Strand)
Project uses 18 pieces. You will need 1 package.
- FCL-01153 - TierraCast Clasp, Jardin Toggle Clasp 20mm, 1 Set, Antiqued Pewter
Project uses 1 piece. You will need 1 package.
- BMB-1003 - Lead-Free Pewter, Smooth Rectangle Beads 3x5mm, 50 Pieces, Antiqued Silver
Project uses 34 pieces. You will need 1 package.
- BMB-1050 - Lead-Free Pewter, Puff Circle Beads with Floral Pattern 9.5mm, 10 Pieces, Antiqued Silver
Project uses 2 pieces. You will need 1 package.
- FCR-4165 - Silver Plated Wire & Thread Protectors .024 Inch Loops (50)
Project uses 2 pieces. You will need 1 package.
- FCR-3108 - BeadSmith Magical Crimp Assortment, 2x2mm, Silver / Gold / Copper / Black Oxide, 500 Pieces
Project uses 2 pieces. You will need 1 package.
- XCR-5493 - Soft Flex, Soft Touch 49 Strand Medium Beading Wire .019 Inch Thick, 30 Feet, Satin Silver
Project uses 28 Inches. You will need 1 package.
RECOMMENDED TOOLS:- XTL-7206 - BeadSmith Magical Crimping Pliers, Transforms 2mm Tubes into Round Beads, 1 Piece
- XTL-5600 - Sharp Flush Cutter Pliers - For Cutting Beading Wire, 1 Piece
- XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
- XTL-3000 - Bead Stopper- Stop Beads Sliding Off Stringing Material