Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
By following the instructions below, you will make one earring. Repeat all instructions to make the second earring.
- Begin by sliding a vintage Czech spun glass lace tear drop bead onto a gold plated head pin. Create a simple wire loop using your round nose pliers. Snip off any excess wire using your flush cutters.
- Next, take another gold plated head pin and snip off the head. Create a simple wire loop. Then slide on your Beadelle bead and create one more simple wire loop. Snip off any excess wire using your flush cutters.
- Open the simple loop on your vintage Czech glass lace tear drop bead (how you would a jump ring) and slide it onto the simple loop on one side of your Beadelle bead and close.
- Lastly, open the loop on your gold plated earring hook (again, how you would a jump ring) and slide it onto the second simple loop on your Beadelle bead and close.
- You're done!
WHAT YOU'LL NEED: (scroll down for purchase options)
- BCV-522 - Vintage Czech Spun Glass, Lace Teardrop 14x30mm, 1 Piece, Turquoise
Project uses 2 pieces. You will need 2 packages.
- BDLL-6150 - Beadelle Crystal Resort Collection 8mm Round Pave Bead - Gold Plated / Coral
Project uses 2 pieces. You will need 2 packages.
- FHP-5220 - 22K Gold Plated Head Pins - 21 Gauge - 2 Inches (50)
Project uses 2 pieces. You will need 1 package.
- FEA-3071 - 22K Gold Plated French Wire Earring Hooks 18MM (25 Pairs)
Project uses 1 pair. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex
- XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers
- XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose