Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
By following the instructions below, you will make one earring. Repeat all instructions to make the second earring.
- Cut two inches of chain.
- Thread the chain through the loop of the drop earring pendant.
- Open a jump ring and attach both sides of the chain to the open jump ring. Before you close it, also attach the ring of the post earring. Make sure the earring drop will face the front before closing the jump ring. Close the jump ring.
- Place the earring back on the post earring.
WHAT YOU'LL NEED: (scroll down for purchase options)
- FJR-5250 - 22K Gold Plated Open Jump Rings 5mm 20 Gauge (100)
Project uses 2 pieces. You will need 1 package.
- CHA-99970 - Bright 22K Gold Plated Long And Short Chain 2.5x4.5mm - Bulk By The Foot
Project uses 4 inches. You will need 1 package.
- FEA-1501 - TierraCast 22K Gold Plated Pewter Stud Earrings Dome Post & Ring 8mm
Project uses 2 pieces. You will need 1 package.
- FEA-1012 - Bullet Clutch Earring Backs, Hypo Allergenic 5.7x5mm, 50 Pieces, Gold Tone
Project uses 2 pieces. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex
- XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose