Retired - Urban Ball Necklace - Rose Gold

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Place onto a head pin 1 Beadelle pave crystal bead. After the bead, create a wrapped wire loop. NOTE: Make sure your wrapped wire loop is large enough to thread your chain through in the next step.
2. Thread one end of your chain through the wrapped wire loop you just made.
3. Your rose gold lobster clasp comes with two jump rings already attached. They are both closed jump rings. If you have a good sharp pair of flush cutters, you can very carefully cut a slit in each of the jump rings to turn them into open jump rings. If you do not have a sharp pair of flush cutters to make a clean cut, you might want to connect a 4mm or 5mm open jump ring to each of the closed jump rings and then also attach these jump rings to the end chain links on your chain.
4. All done!

• BDLL-0110 - Beadelle Crystal 10mm Round Pave Bead - Rose Gold Plated / Crystal (1 Piece)
  Project uses 1 piece. You will need 1 package.


• CHA-6134 - Genuine Copper Cable Chain 2.3mm x 1.8mm - By The Foot
  Project uses 36 inches. You will need 3 packages.


• FCL-2051 -
  Project uses 1 piece. You will need 1 package.


• FHP-1039 - Head Pins, 1.5 Inches Long and 22 Gauge Thick, 50 Pieces, Copper
  Project uses 1 piece. You will need 1 package.

• XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers
• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex