Retired - Tiger's Romance

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. The first step to making this necklace is to make sure that the chain ends are trimmed properly so that you have a nice clean loop to attach a jump ring to. To see how to trim the ends, please watch the video: How to Properly Cut Gemstone Chain.
2. Open a jump ring and attach it to one end of your chain. Close the jump ring.
3. On the other side of the chain, attach a jump ring and close it. Open another jump ring and link onto it the jump ring you just attached as well as a lobster clasp. Close the jump ring.
4. Take your now finished gemstone necklace and fold it in half so you can find the mid-way point. At the mid way point attach a jump ring and also link onto it the tiger pendant. Close the jump ring.

• SWCR-1165 - Austrian Crystal, 67511 Tiger Pave Pendant 22mm, 1 Piece, Smoked Topaz / Gold
  Project uses 1 piece. You will need 1 package.


• FJR-5452 - 22K Gold Plated Open Jump Rings 4mm 22 Gauge (50)
  Project uses 4 pieces. You will need 1 package.


• CHX-1311 - Vermeil Gold Wire Wrapped Gemstone Chain, 3mm Micro Faceted Drops, 1 Inch, Multi
  Project uses 20 inches. You will need 20 packages.


• FCL-2514 - Beautiful Gold Plated Curved Lobster Clasps 10mm (10)
  Project uses 1 piece. You will need 1 package.

• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex