Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
- Cut a piece of faux suede cord at twenty-eight inches long.
- To make the necklace adjustable, tie either end in a simple knot about three inches down around the opposite side of the cord. Leave about a quarter of an inch of the excess cord and trim off anything longer than that. Set aside.
- To create the lava and jasper charm, insert a headpin through two jasper beads, a lava bead, and two more jasper beads. Create a simple loop and trim off excess wire.
- Add the small jump ring to the hole on the brass dog tag.
- Gently open the large jump ring and to it add the dog tag, the feather, and the lava and jasper charm. Close again.
- Pull the necklace cord taut with the adjustable knot at one end.
- Thread the other end through the large jump ring so that a one inch loop protrudes.
- Thread the adjustable knot end of the necklace through the loop, and tighten.
WHAT YOU'LL NEED: (scroll down for purchase options)
- XCR-43105 - Beadsmith Dark Brown Faux Leather Suede Beading Cord 9Ft (3 Yd) Spool
Project uses 28 inches. You will need 1 package.
- FHP-5522 - Vintaj Natural Brass Head Pins 21 Gauge 2 Inch (20)
Project uses 1 piece. You will need 1 package.
- FJR-5372 - Vintaj Natural Brass Jump Rings 7.25mm Open 16 Gauge (20)
Project uses 1 piece. You will need 1 package.
- FJR-5335 - Vintaj Natural Brass Open Jump Rings 15mm Heavy 15 Gauge (10)
Project uses 1 piece. You will need 1 package.
- PND-7154 - Vintaj Natural Brass Dog Tag Pendant 32mm x 19mm (1)
Project uses 1 piece. You will need 1 package.
- SPJA-191 - Paint Brush Desert Jasper 6mm Heishe Beads 15.5 Inch Strand
Project uses 4 pieces. You will need 1 package.