Retired - The Czarina Bracelet

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. You can see how to make this bracelet step by step by watching this video.
2. You'll need to bend the bezel openings on a Nunn Design collage bracelet out a little to accommodate the engraved cabochons. Test each cabochon where you want to place it first to make sure it doesn't already fit.
3. Use a pair of chain nose pliers to gently bend the bezel edges slightly outward. Continue to test the cabochons until they fit.
4. Apply some E6000 glue into the empty bezel settings. Make sure there is enough glue to make contact with the cabochons if they don't set all the way in, but not too much glue.
5. Place the cabochons into the bezel settings and allow to dry thoroughly before wearing.

• AXC-9460 - Nunn Design Antiqued Gold Tone Collage Bracelet Lrg 18mm Round -7.5Inch
  Project uses 1 piece. You will need 1 package.


• SPCB-1435 - Czech Glass, Engraved Round Cabochons with Gilded Floral Motif 18mm, 2 Pieces, Gold/Jet on Red
  Project uses 1 piece. You will need 1 package.


• SPCB-1437 - Czech Glass, Engraved Round Cabochons with Gilded Floral Motif 18mm, 2 Pieces, Gold/White on Blue
  Project uses 2 pieces. You will need 1 package.


• SPCB-1438 - Czech Glass, Engraved Round Cabochons with Gilded Floral Motif 18mm, 2 Pieces, Gold/White on Jet
  Project uses 2 pieces. You will need 1 package.


• XTL-1054 - E6000 Industrial Strength Glue Adhesive (0.18 fl oz)
  Project uses 1 tube. You will need 1 package.

• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose