Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
This finished design will give you an 18" necklace. To modify the length, adjust the length of each side of chain.
- Begin by cutting two pieces of chain, 8 inches each.
- Open one jump ring. Attach one end of one piece of the chain to the jump ring and close the jump ring.
- Move to the other side of this chain and open one more jump ring. Attach this end of the chain to one loop of the arrow connector. Close the jump ring.
- Onto the other side of the arrow connector, attach the second piece of chain with a jump ring, same as before.
- Move to the end of the piece of chain you just added. Open one jump ring and attach it to the chain and to a lobster clasp. Close the jump ring.
- All done!
WHAT YOU'LL NEED: (scroll down for purchase options)
- CHA-2400 - Silver Plated 2mm x 2.4mm Cable Chain - By The Foot
Project uses 16 Inches. You will need 2 packages.
- FJR-5454 - Silver Plated Open Jump Rings 4mm 22 Gauge (50)
Project uses 4 pieces. You will need 1 package.
- FCL-2507 - Silver Plated Curved Lobster Clasps 8mm (10)
Project uses 1 piece. You will need 1 package.
- FCO-1402 - Nunn Design Connector, Arrow 7.5x36.5mm, 1 Piece, Antiqued Silver Plated
Project uses 1 piece. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex
- XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
- XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers