Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available,
may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND
OTHER SUPPLIES sections for current availability.
Looking at the bangle, there is a side where there are two stud rivets that are closed. I will use these as a point of reference for these instructions.
- Open one jump ring and attach it to the first open eyelet directly to the left of the center rivets. Attach one hole of the triangle link. Close the jump ring.
- Move one eyelet to the left and open one jump ring, attach the second hole of the triangle link. Close the jump ring.
- Next, move two eyelets to the left. Open one jump ring, attach the heart charm to the jump ring, and link one end link of the length of chain. Close the jump ring.
- Stringing the chain along the bangle, move to the right by one eyelet. Using a jump ring attach the 13th link to the bangle. Close the jump ring.
- Move to the right and using a jump ring attach the 19th link of the chain to the bottom hole of the triangle link. Close the jump ring.
- Move to the right by one eyelet. Using a jump ring attach the 28th link to the bangle. Close the jump ring.
- Move to the right by one eyelet. Using a jump ring attach the 41st link to the bangle. Close the jump ring.
- Move to the right by one eyelet. You will be back at the heart charm. Open the jump ring once again and attach the 52nd link to the bangle, behind the heart charm. Close the jump ring.
- Cut off any remaining chain.
Note: You will have additional chain, so you can adjust the lengths within the bangle accordingly.
WHAT YOU'LL NEED: (scroll down for purchase options)
- CHA-99915 - Antiqued Brass Curb Chain 6mm x 5mm Bulk By The Foot
Project uses 1 Foot. You will need 1 package.
- FJR-5175 - Antiqued Brass Open Jump Rings 7mm 19 Gauge (20)
Project uses 7 pieces. You will need 1 package.
- JB-2715 - TierraCast Bracelet, Round Bangle 2.5 Inches 20 Gauge, 1 Bracelet, Brass Oxide Finish
Project uses 1 piece. You will need 1 package.
- FCO-01200 - TierraCast Connector Link, Flora 3-Hole Triangle 11mm, 2 Pieces, Brass Oxide Finish
Project uses 1 piece. You will need 1 package.
- PND-0262 - TierraCast Charm, Amor Small Heart 13.5x15mm, 1 Piece, Brass Oxide Finish
Project uses 1 piece. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5600 - Sharp Flush Cutter Pliers - For Cutting Beading Wire, 1 Piece
- XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
- XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers