Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
By following the instructions below, you will make one earring. Repeat all instructions to make the second earring.
- Onto a head pin place: 1 Austrian crystal dome bead facing downwards, 1 angel wings bead, 1 Austrian crystal round bead, and 1 scalloped bead cap facing upwards.
- Create a simple wire loop after the bead cap. Trim excess wire with flush cutters.
- Open the loop at the base of your earring hook (the same way you would open a jump ring) and link this onto the simple wire loop you just made. Close the loop back up.
- Happy Holidays!
WHAT YOU'LL NEED: (scroll down for purchase options)
- BMB-3287 - TierraCast Fine Silver Plated Pewter Scalloped Bead Caps 3.5mm (12)
Project uses 2 pieces. You will need 1 package.
- SWBB-7781 - Austrian Crystal, 5542 Dome Beads 8mm, 2 Pieces, Crystal AB
Project uses 2 pieces. You will need 1 package.
- SWC-0401 - Austrian Crystal, 5000 Round Beads 4mm, 12 Pieces, Crystal AB
Project uses 2 pieces. You will need 1 package.
- BMB-3370 - TierraCast Fine Silver Plated Pewter Angel Wing Beads 14mm (4)
Project uses 2 pieces. You will need 1 package.
- FHP-5325 - Silver Plated Head Pins 2 Inches/21 Gauge (X50)
Project uses 2 pieces. You will need 1 package.
- FEA-3025 - Silver Plated Long Elegant Earring Hooks (50)
Project uses 2 pieces. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
- XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers
- XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex