Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
- Cut the following lengths of chain: cut two pieces at six inches long, two pieces at nine inches long, one at an inch and a half, one at two and a half inches long, and one at three and a half inches long.
- Add an oval jump ring to each of the four loops on the antiqued silver art deco stamping. To each of the two top (vertical) jump rings, add one six inch piece of chain and one nine inch piece of chain. Close these jump rings again.
- Create two short chains by linking together four (per chain) oval jump rings. Link one end of each jump ring chain to one end of each set of six and nine inch long chains.
- Onto three head pins, thread a single Czech cathedral bead each. Create a simple loop on each head pin and trim off excess wire.
- Open the loop on one of the head pin dangles and add it to the end of one of the jump ring chains, then close the loop again. Open the last jump ring on the other jump ring chain and add a lobster clasp. Close this jump ring again.
- To the two jump rings at the bottom of the stamping, add both ends of the three short pieces of chain. Add the last two head pin dangles to the jump rings before closing once more.
WHAT YOU'LL NEED: (scroll down for purchase options)
- FCO-7018 - Art Deco Stamping Antiqued Silver Plated Rectangles 4 Hole Connector Link 32.2mm (1 1/4IN.)
Project uses 1 piece. You will need 1 package.
- FCL-2540 - Antiqued Silver Plated Sleek Lobster Claw Clasps 15mm (6)
Project uses 1 piece. You will need 1 package.
- FJR-5405 - TierraCast Rhodium Plated Brass Open Oval Jump Rings 6mm 20 Gauge (50)
Project uses 12 pieces. You will need 1 package.
- CHA-9685 - Antiqued Silver Plated Flat Link Cable Chain 4.3mm Bulk By The Foot
Project uses 3 feet. You will need 3 packages.
- BCP-6306 - Czech Cathedral 4x6mm Oval Glass Beads - 'Jet' Black / Silver Ends (25)
Project uses 3 pieces. You will need 1 package.
- FHP-5323 - Silver Plated Head Pins 1.5 Inches Long/21 Gauge (x50)
Project uses 3 pieces. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex
- XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
- XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers