Sparkle Burst Earrings

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. To make this earring, start by placing the bicone bead, followed by the round bead, onto a head pin.
2. Create a wrapped wire loop after the round bead and trim off excess wire.
3. Open the loop at the base of the earring hook, the same way you would open a jump ring, and slide on the wrapped wire loop from the previous step. Close the loop.
4. Repeat the previous 3 steps to make your matched earring pair. Enjoy!

• FEA-9553 - Earring Findings, French Wire Hook with Ball 23mm Long 23 Gauge Silver-Filled (3 Pairs)
  Project uses 1 pair. You will need 1 package(s).


• FHP-8010 - Silver-Filled Head Pins 24 Gauge 1 1/2 Inch (20 Pieces)
  Project uses 2 piece(s). You will need 1 package(s).


• PRES-5000-CRYSAB12 - PRESTIGE Crystal, #5000 Round Bead 12mm, Crystal AB (1 Piece)
  Project uses 2 piece(s). You will need 2 package(s).


• PRES-5328-ABO4 - PRESTIGE Crystal, #5328 Bicone Bead 4mm, Air Blue Opal (1 Piece)
  Project uses 2 piece(s). You will need 2 package(s).

• XTL-5032 - The Beadsmith Wire Looping Pliers - Concave And Round Nose
• XTL-5450 - Xuron Jeweler's Super Fine Pliers Chain Nose Flat Nose
• XTL-5600 - Sharp Flush Cutter Pliers - For Cutting Beading Wire (1 Piece)
• XTL-0020 - Baby Wubbers Quality Fine Chain Nose Jeweller's Pliers