Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
Remember to double these instructions to create your matched pair of earrings.
- Place an 8mm crystal comet argent light cube bead, a silver plated squaredelle spacer bead with rose crystals, and a 6mm rondelle spacer bead onto a 1.5", 22 gauge sterling silver head pin.
- Create a simple wire loop after the spacer bead.
- Cut a 1.5" length of sterling silver 2mm flat cable chain.
- pen the wire loopO on your head pin and insert it into one of the end links of your piece of chain. Close the loop.
- Gently open the loop on a sterling silver leverback earring and insert it into the loose end link of your chain. Close the loop.
WHAT YOU'LL NEED: (scroll down for purchase options)
- BCZ-3820 -
Project uses 2 pieces. You will need 1 package.
- SWC-2812 - Austrian Crystal, 5601 Cube Beads 8mm, 4 Pieces, Crystal Comet Argent Light (CAL)
Project uses 2 pieces. You will need 1 package.
- SWC-5303 - Austrian Crystal, 5305 Rondelle Spacer Beads 6mm, 8 Pieces, Crystal
Project uses 2 pieces. You will need 1 package.
- FHP-02310 - Head Pins, 1 Inch Long and 22 Gauge Thick, 20 Pieces, Sterling Silver
Project uses 2 pieces. You will need 1 package.
- FEA-05010 - Earring Findings, Classic Leverback 16x10mm, 2 Pieces, Sterling Silver
Project uses 2 pieces. You will need 1 package.
- CHA-1619 - Sterling Silver Flat Cable Chain 2mm Unfinished Bulk By The Foot
Project uses 3 inches. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
- XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex
- XTL-5032 - Beadsmith Wire Looping Pliers - Concave And Round Nose