Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
By following the instructions below you will make one earring. Repeat all instructions to make the second earring.
- Cut 4 lengths of chain, 3 1/2 inches each.
- Open one 4mm jump ring. Take one length of chain and fold it in half. Take the center link in the chain and string it on to the jump ring. Add the other three chains in the same way. Close the jump ring.
- Open one 5mm jump ring and attach the 4mm jump ring with the chains, and the star tag charm, so that the chain is hanging behind the star. Close the jump ring.
- Open one 4mm jump ring and attach the 5mm jump ring and the earring lever back. You will want to make sure that the lever back faces the same side of the star with the chain behind it. This is the back. Close the jump ring.
- All done!
WHAT YOU'LL NEED: (scroll down for purchase options)
- PND-3319 - Nunn Design Flat Tag Charm, Star 13.5mm, Antiqued Gold Plated
Project uses 2 pieces. You will need 2 packages.
- CHA-9631 - Antiqued 22K Gold Plated Oval Cable Chain 2mm Bulk By The Foot
Project uses 28 Inches. You will need 3 packages.
- FJR-5457 - 22K Gold Plated Open Jump Rings 5mm 21 Gauge (50)
Project uses 2 pieces. You will need 1 package.
- FJR-5452 - 22K Gold Plated Open Jump Rings 4mm 22 Gauge (50)
Project uses 4 pieces. You will need 1 package.
- FEA-8226 - Nunn Design Antiqued 24kt Gold Plated Leverback Earring Findings 18mm - 2 Pair
Project uses 2 pieces. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex
- XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
- XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers