Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
- Start by finding the mid point of your necklace. You can do this by holding your premade necklace by the clasp and letting the two sides drop. Find the middle chain link.
- Open a 6mm jump ring and link it to your princess cut pendant as well as that middle chain link. Close the jump ring. You have now established the middle of your necklace and in a future step will be counting chain links along the sides from this middle point.
- Place a sapphire bicone onto a head pin. Create a wrapped wire loop immediately after the bicone and trim off excess wire with flush cutters. Repeat this step 7 more times so that you have a total of 8 sapphire dangles created.
- Repeat the previous step but using aquamarine shimmer bicones. Create a total of 6 of these dangles.
- From your middle point, count 12 chain links up on one side of the necklace. Open a 4mm jump ring and link onto it 2 sapphire dangles and 1 aquamarine dangle. Link this jump ring with dangles to that 12th chain link on the side of your necklace. Close the jump ring.
- Repeat the previous step except this time count 12 chain links from the dangle cluster you just attached. Attach another 3 bead cluster. Then attach another cluster 12 chain links from the cluster you just attached so that you have 3 of these bead clusters on the side of your necklace.
- Repeat the previous 2 steps so that you complete 3 more clusters of 3 beads on the other side of your necklace.
- Enjoy!
WHAT YOU'LL NEED: (scroll down for purchase options)
- AXC-98930 - Silver Plated Fine Cable Chain Necklace with Lobster Clasp - 2x1.8mm Links 18 Inches Long
Project uses 1 piece. You will need 1 package.
- FHP-3005 - Silver Plated Ball Head Pins 22 Gauge 1.5 Inch (x20)
Project uses 18 pieces. You will need 1 package.
- FJR-5454 - Silver Plated Open Jump Rings 4mm 22 Gauge (50)
Project uses 6 pieces. You will need 1 package.
- FJR-5467 - Silver Plated Open Jump Rings 6mm 21 Gauge (50)
Project uses 1 piece. You will need 1 package.
- SWBI-14420 - Austrian Crystal, 5328 Bicone Beads 4mm, 24 Pieces, Aquamarine Shimmer
Project uses 6 pieces. You will need 1 package.
- SWBI-1427 - Austrian Crystal, 5328 Bicone Beads 4mm, 24 Pieces, Sapphire Blue
Project uses 12 pieces. You will need 1 package.
- SWCR-6437 - Austrian Crystal, 6431 Princess Cut Pendant 16mm, 1 Piece, Sapphire
Project uses 1 piece. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5450 - Xuron Jeweler's Super Fine Pliers Chain Nose Flat Nose
- XTL-0020 - Baby Wubbers Quality Fine Chain Nose Jeweller's Pliers
- XTL-7213 - BeadSmith Simply Modern Series, Round Nose Pliers, 4.75 Inches Long
- XTL-5600 - Sharp Flush Cutter Pliers - For Cutting Beading Wire, 1 Piece