Retired - Sacre Coeur Earrings

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Begin by stringing onto your ball head pin: one heart-shaped bead and one black bicone.
2. Next, create a simple wire loop at the top using your round nose pliers. Snip off any excess wire using your flush cutters.
3. Unhook your silver plated earring hook wire and slide through the loop on your heart-shaped bead. Close up the hook.
4. Your earring is now ready.

• BCP-5162 - Czech Glass Table Cut Window Beads 15mm Heart - Opaque Red / Picasso (6)
  Project uses 2 pieces. You will need 1 package.


• FEA-6600 - Silver Plated Earring Hooks Kidney Wires Extra Extra Long 2 Inch (2 Pairs)
  Project uses 2 pieces. You will need 1 package.


• FHP-3002 - Silver Plated 2mm Ball Head Pins 21 Gauge 2 Inches (x20)
  Project uses 2 pieces. You will need 1 package.


• BCZ-5415 - Preciosa Czech Crystal 4mm Bicone Beads 'Jet Black' (50)
  Project uses 2 pieces. You will need 1 package.

• XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers
• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex