Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
By following the instructions below, you will make one earring. Repeat all instructions to make the second earring.
- Onto your gold plated ball head pin, slide 1 ruby glass faceted drop bead, 1 gold plated hexagon spacer bead, and 1 green turquoise Czech glass Druk bead.
- Create a simple wire loop using your round nose pliers. Snip off any excess wire with your flush cutters.
- Next, open your kidney ear wire and slide on your simple wire loop. Close your earring hook back up.
- That's it!
WHAT YOU'LL NEED: (scroll down for purchase options)
- BGL-08002 - Simulated Ruby Glass Beads, 10x15mm Faceted Drops, 10 Pieces, Ruby Red
Project uses 2 pieces. You will need 1 package.
- FEA-6702 - 22K Gold Plated Earring Hooks Kidney Wires 25mm (10 Pairs)
Project uses 2 pieces. You will need 1 package.
- FHP-3027 - 22K Gold Plated Ball Head Pins 22 Gauge 1.5 Inch (x20)
Project uses 2 pieces. You will need 1 package.
- BMB-3221 - TierraCast 22K Gold Plated Pewter Hexagon Spacer Beads 3.8mm (50)
Project uses 2 pieces. You will need 1 package.
- BCP-7466 - Czech Glass Druk 4mm Round Green Turquoise Beads (100)
Project uses 2 pieces. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5600 - Sharp Flush Cutter Pliers - For Cutting Beading Wire, 1 Piece
- XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers
- XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose