Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
Please remember to double these instructions to create your matched pair of earrings.
- Place a 10mm ivory crystal round faux pearl onto a 2", 21 gauge gunmetal eye pin, followed by a black finish pewter spiral cone bead cap. Create a wrapped wire loop after the bead cap.
- Place a 7mm black finish pewter casbah bead onto a 1.5", 21 gauge gunmetal head pin and create a simple wire loop. Use the wire loop to hang the casbah bead from the bottom of the ivory pearl.
- Open the loop on a gunmetal plated small earring hook and hang the earring from it; close the loop.
WHAT YOU'LL NEED: (scroll down for purchase options)
- BMB-5610 - TierraCast Black Finish Pewter 'Spiral' Cone Bead Caps 8.5mm (2)
Project uses 2 pieces. You will need 1 package.
- BMB-5609 - TierraCast Black Finish Pewter Round 'Casbah' Beads 7mm (4)
Project uses 2 pieces. You will need 1 package.
- SWP-1045 - Austrian Crystal, 5810 Round Faux Pearl Beads 10mm, 10 Pieces, Ivory
Project uses 2 pieces. You will need 1 package.
- FHP-6318 - Gun Metal Plated Head Pins 1.5 Inches/21 Gauge (50)
Project uses 2 pieces. You will need 1 package.
- FHP-6270 - Gunmetal Grey Brass Open Eye Pins 21 Gauge 2 Inch (x50)
Project uses 2 pieces. You will need 1 package.
- FEA-3313 - Gunmetal Plated Small Earring Hooks 16mm (20 Pairs)
Project uses 2 pieces. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
- XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex
- XTL-5032 - Beadsmith Wire Looping Pliers - Concave And Round Nose