Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
In addition to the materials listed, you will also need a toothpick or scrap of wire. These instructions will make a 24 inch necklace. For a longer or shorter necklace, adjust the length of chain used (for a longer necklace, you will have to purchase an additional foot of chain).
- Take a bit of E6000 glue on the tip of a toothpick or a scrap of wire. Dab the glue around the inner edge of 1 Nunn Design open back bezel. Take 1 Austrian crystal crystal cushion fancy stone and press it into the bezel. Let the glue dry for 14-16 hours, or overnight.
- Using flush cutters, cut two 12 inch lengths of chain.
- Open a jump ring. Slide it through the loop at the top of the open back bezel charm, and also slide it onto the gold hoop. Close the jump ring.
- Open another jump ring. Slide it through the first link of one length of chain, and also slide it onto the gold hoop. Close the jump ring.
- Open another jump ring. Slide it through the first link of your second length of chain, and also slide it onto the gold hoop. Close the jump ring.
- Open another jump ring. Slide it through the last link on one side of your necklace, and also slide on the loop of your clasp. Close the jump ring.
- Open another jump ring. Slide it through the last link on the other side of your necklace. Close the jump ring. Enjoy your necklace!
WHAT YOU'LL NEED: (scroll down for purchase options)
- PND-910 - Nunn Design Open Back Bezel Charm, Sqaure 17x21mm, 1 Piece, Antiqued Gold
Project uses 1 piece. You will need 1 package.
- SWCR-4376 - Austrian Crystal, 4470 Cushion Fancy Stone 12mm, 1 Piece, Crystal Foiled
Project uses 1 piece. You will need 1 package.
- PND-08343 - Nunn Design Open Frame, Hoop 24.5mm, 1 Piece, Antiqued Gold
Project uses 1 piece. You will need 1 package.
- FCL-7529 - Nunn Design Antiqued 24kt Gold Plated Lobster Clasps 19mm (2)
Project uses 1 piece. You will need 1 package.
- FJR-5220 - 22K Gold Plated Open Jump Rings 6mm 20 Gauge (20)
Project uses 5 pieces. You will need 1 package.
- CHA-9810 - Nunn Design Antiqued Gold Plated Chain Flat Cable 4mm By The Foot
Project uses 24 inches. You will need 2 packages.
- XTL-1054 - E6000 Industrial Strength Glue Adhesive (0.18 fl oz)
Project uses 1 piece. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
- XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers
- XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex