Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
In addition to the materials listed, you will also need a toothpick or scrap of wire. These instructions will make a 7 inch bracelet. For a longer or shorter bracelet, adjust the length of chain used.
- Take a bit of E6000 glue on the tip of a toothpick or a scrap of wire. Dab the glue around the inner edge of 1 Nunn Design open back bezel. Take 1 Austrian crystal crystal cushion fancy stone and press it into the bezel. Let the glue dry for 14-16 hours, or overnight.
- Using flush cutters, cut 6 inches of textured chain.
- Open a jump ring. Slide it through the loop at the top of the open back bezel charm, and also slide it onto the silver hoop. Close the jump ring.
- Open another jump ring. Slide it onto the silver hoop, and also slide it through the first link of your length of chain. Close the jump ring.
- Open another jump ring. Slide it through the last link of your length of chain, and also slide it through the loop of your clasp. Close the jump ring.
- Fasten the clasp around the silver hoop to close your bracelet. Enjoy!
WHAT YOU'LL NEED: (scroll down for purchase options)
- PND-912 - Nunn Design Open Back Bezel Charm, Sqaure 17x21mm, 1 Piece, Bright Silver
Project uses 1 piece. You will need 1 package.
- SWCR-4269 - Austrian Crystal, 4470 Cushion Fancy Stone 12mm, 1 Piece, Scarlet Foiled
Project uses 1 piece. You will need 1 package.
- PND-08345 - Nunn Design Open Frame, Hoop 24.5mm, 1 Piece, Bright Silver
Project uses 1 piece. You will need 1 package.
- FJR-5160 - Silver Plated Open Jump Rings 6mm 19 Gauge (x100)
Project uses 3 pieces. You will need 1 package.
- FCL-7531 - Nunn Design Silver Plated Lobster Clasps 19mm (2)
Project uses 1 piece. You will need 1 package.
- CHA-9800 - Nunn Design Silver Plated Textured Cable Chain 9mm By The Ft
Project uses 6 inches. You will need 1 package.
- XTL-1054 - E6000 Industrial Strength Glue Adhesive (0.18 fl oz)
Project uses 1 piece. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
- XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers
- XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex