Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
- Begin by cutting two 4' lengths and two 18" lengths of size 18 coral Super-Lon nylon cord.
- Take one 4' length and one 18" length and fold them each in half, with the center folds together. Insert the folded ends of your cord down through a Tierracast Infinity Link so that a loop is formed coming out the bottom of the link. Then bring the ends of the cord (all four pieces) through the loop and pull tight to form a larks head knot.
- Use the longer cords to tie square knots onto the shorter cords. Continue until the knotting measures about 2 1/4" and then finish off your knotting as demonstrated in this video. Make sure to add a dab of E6000 into the knot and trim the outside cords close after the glue dries.
- Repeat this process with the other lengths of cord on the other side of the ring.
- Measure about 3" from the end of the knotting and tie the inner cords together in an overhand knot on each side.
- Then use one of the longer scraps of cord to create a sliding knot clasp with four square knots as demonstrated in this video. (Make sure to add a dab of E6000 into the knot and trim the cords close after the glue dries.)
WHAT YOU'LL NEED: (scroll down for purchase options)
- XCR-4329 - BeadSmith Super-Lon Cord - Size 18 Twisted Nylon - Chinese Coral / 77 Yards
Project uses 1 spool. You will need 1 package.
- FCO-9224 - TierraCast Brass Oxide Finish Lead-Free Pewter Infinity Connector Link 12x31.5mm (2)
Project uses 1 piece. You will need 1 package.
- XTL-1054 - E6000 Industrial Strength Glue Adhesive (0.18 fl oz)
Project uses 1 piece. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex