Retired - Quite an Affair Ring

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Watch the instructional video: How to Use Crystal Clay.
2. Prepare a piece of gold crystal clay and smooth it into the gold tone bezel ring base.
3. Press the blue engraved glass button into the center of the bezel until the button shank rests against the bottom of the bezel.
4. Smooth the clay around the edges of the button, removing any excess.
5. Cut a piece of crystal AB gold plated rhinestone chain long enough to fit in the space around the button and press it into place. Press it down until the rhinestones sit (slightly angled toward the edge of the bezel) at the same level as the button.
6. Allow the clay to fully cure before wearing.

• PND-0155 - Czech Glass, Engraved Round Buttons with Swirl 23mm, 2 Pieces, Blue AB on Jet
  Project uses 1 piece. You will need 1 package.


• FRG-0850 - Gold Tone Brass 30mm Round Bezel Adjustable Ring (1)
  Project uses 1 piece. You will need 1 package.


• CHA-2022 - Austrian crystal Gold Plated Rhinestone Cup Chain 24PP Crystal AB - BY THE FT
  Project uses 1 foot. You will need 1 package.


• TRC-238 - Crystal Clay 2-Part Epoxy Clay Kit 'Gold' 25 Grams
  Project uses 1 piece. You will need 1 package.

• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex