Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
By following the instructions below, you will make one earring. Repeat all instructions to make the second earring.
- Open the jump ring attached to the charm and remove it from the charm. Discard this jump ring, you will not need it for this project.
- Take your flat nose pliers to bend the flattened end of the beading hoop up.
- Onto the beading hoop, string one black seed bead, one angel wing, followed by 48 seed beads.
- To the end of this beading hoop, make a simple wire loop. Trim the excess wire with your flush cutters.
- Open the loop of the earring hook, the same way you would a jump ring and thread it through the hole at the top of the beading loop. Close the loop.
- All Done!
WHAT YOU'LL NEED: (scroll down for purchase options)
- JSK-0242 - Toho Round Seed Beads 11/0 49F 'Opaque Frosted Jet' 8 Gram Tube
Project uses 1 tube. You will need 1 package.
- PND-10500 - Silver Plated and Enameled Charm, Angel Wing (Left) 24x9x3mm, 1 Piece, Black
Project uses 1 piece. You will need 1 package.
- PND-10563 - Silver Plated and Enameled Charm, Angel Wing (Right) 24x9x3mm, 1 Piece, Black
Project uses 1 piece. You will need 1 package.
- FEA-3015 - Silver Plated Fishhooks Earring Hooks (50)
Project uses 2 pieces. You will need 1 package.
- FEA-7107 - Silver Plated Beading Hoop Earrings 1 1/4 Inch (20)
Project uses 2 pieces. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
- XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers
- XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex