Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
- Open the jump rings to separate four links of silver plated crystal channel chain, leaving a jump ring on each end.
- Place a silver plated 1.5", 22 gauge head pin through an 11mm white teardrop faux pearl and create a wrapped wire loop after the bead.
- Open the jump ring on one end of the chain and hang the pearl drop from it; close the ring.
- Use a silver plated 4mm, 21 gauge jump ring to hang the other end of the chain from the loop on a silver plated ball post earring. Make sure you have the included jump ring on the chain and a second jump ring here so that the channel chain hangs properly.
- Place a silver plated earring back onto the earring post.
- Repeat steps 1 - 5 to create a second earring.
WHAT YOU'LL NEED: (scroll down for purchase options)
- CHA-2010 - Austrian crystal Rhodium Plated Channel Crystal Chain Crystal 6.8mm - BY THE FT
Project uses 1 piece. You will need 1 package.
- SWP-1101 - Austrian Crystal, 5821 Pear Shaped Faux Pearl Beads 11mm, 4 Pieces, White
Project uses 2 pieces. You will need 1 package.
- FEA-1045 - Silver Plated Stud Earrings Ball Post & Ring 4mm (20)
Project uses 2 pieces. You will need 1 package.
- FHP-5315 - Silver Plated Head Pins 1.5 Inches Long 22 Gauge Thick (50 Pieces)
Project uses 2 pieces. You will need 1 package.
- FJR-5140 - Silver Plated Open Jump Rings 4mm 21 Gauge Thick (100)
Project uses 2 pieces. You will need 1 package.
- FEA-1013 - Silver Plated Earring Backs (Earnuts) Med. (100)
Project uses 2 pieces. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose