Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
Remember to double these directions to make your matched pair of earrings.
- Start this project by using your fingers to gently fold one of your bead caps in half. Do not fold it all the way, but squish it enough so that it will cup the base of your Golem Studios bead. If the bead cap is too strong for your fingers to bend, use your chain nose pliers to ease the sides together. Repeat with a second bead cap.
- Onto a head pin place 1 of your squished bead caps from above, a Golem Studios lentil bead, and the second squished bead cap.
- After the last bead cap, start to create a wrapped wire loop. After you have created the loop but before you make your wraps, insert into the loop the hoop at the base of your antique brass stud earring post with ball. Finish making your wraps. Cut off excess wire with flush cutters.
- All done!
WHAT YOU'LL NEED: (scroll down for purchase options)
- BMB-6840 - Antiqued Brass Beaded 7-Petal Flower Bead Caps - 9mm (24)
Project uses 4 pieces. You will need 1 package.
- BWC-596 - Golem Design Studio Ceramic Beads, 18mm Glazed Lentil Mosaic Pattern, 2 Pieces, Green Tones
Project uses 2 pieces. You will need 1 package.
- FHP-06303 - Antiqued Brass Head Pins - 21 Gauge 3 Inches (25)
Project uses 2 pieces. You will need 1 package.
- FEA-1070 - Antiqued Brass Stud Earrings Ball Post & Ring 4mm (20)
Project uses 1 pair. You will need 1 package.
- FEA-1021 - Antiqued Brass Earring Backs (Earnuts) Medium (50)
Project uses 2 pieces. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
- XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex
- XTL-5032 - Beadsmith Wire Looping Pliers - Concave And Round Nose