Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
By following the instructions below you will make one earring. Repeat all instructions to make the second earring.
- Take one pearl and thread it on to one eye pin. Make a simple wire loop. Set aside.
- Next open one jump ring and attach it to one earring post and to one loop of the pearl component. Close the jump ring.
- Open another jump ring and attach it to the other loop of the pearl. Close the jump ring. Repeat with another jump ring so that it sits side by side this jump ring.
- Finally, open another jump ring and attach it to the two jump rings you just added and to one sea glass pendant. Close the jump ring and repeat with another jump ring so that it sits side by side this jump ring.
WHAT YOU'LL NEED: (scroll down for purchase options)
- BGL-9797 - Cultured Sea Glass, Curved Square Pendants 22x22mm, 2 Pieces, Amber
Project uses 2 pieces. You will need 1 package.
- SWP-8037 - Austrian Crystal, #5810 Round Faux Pearl Beads 8mm, 25 Pieces, Iridescent Dark Blue
Project uses 2 pieces. You will need 1 package.
- FJR-5176 - 22K Gold Plated Open Jump Rings 7mm 18 Gauge (50)
Project uses 10 pieces. You will need 1 package.
- FEA-1048 - 22K Gold Plated Stud Earrings Ball Post & Ring 4mm (20)
Project uses 2 pieces. You will need 1 package.
- FHP-6257 - 22K Gold Plated Open Eye Pins 22 Gauge 1.5 Inch (x50)
Project uses 2 pieces. You will need 1 package.
- FEA-1012 - Bullet Clutch Earring Backs, Hypo Allergenic 5.5x5mm, 50 Pcs, Gold Tone
Project uses 2 pieces. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
- XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers
- XTL-5600 - Sharp Flush Cutter Pliers - For Cutting Beading Wire, 1 Piece