Retired - Margot Earrings

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Start by cutting off 6" of chain. Attach three jump rings to the three holes at the bottom of the pendant. By opening the jump rings. Leave them open.
2. On one of the outside rings place one side of the chain. Scoop the chain approx 11/2" to bring to the other outside jump ring. Then scoop back to the first jump ring with approx 1" of chain to create a tiered effect.
3. To both the outside rings, slide a bicone crystal on to the front jump ring of the earring to cover the chain in the back. Close both those jump rings.
4. For the jump ring in the middle, attach the teardrop crystal. Close that jump ring.
5. Open the earring finding, the same way you would a jump ring, and attach to the top of the pendant. Close the earring finding to secure.

• PND-7394 - Vintaj Natural Brass Chandalier Bohemian Drop Pendant 20.5 x 29.5mm (2)
  Project uses 2 pieces. You will need 1 package.


• FJR-5175 - Antiqued Brass Open Jump Rings 7mm 19 Gauge (20)
  Project uses 6 pieces. You will need 1 package.


• SWC-4017 - Austrian Crystal, 6106 Pear Pendant 16mm, 2 Pieces, Provence Lavender / Chrysolite Blend
  Project uses 2 pieces. You will need 1 package.


• CHA-10071 - Vintaj Natural Brass 4x3mm Small Cable Chain - Sold By The Foot
  Project uses 12 pieces. You will need 1 package.


• FEA-6620 - Vintaj Natural Brass Classic French Ear Wire 20mm (2 Pair)
  Project uses 2 pieces. You will need 1 package.

• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex
• XTL-5032 - Beadsmith Wire Looping Pliers - Concave And Round Nose