Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
By following the instructions below you will make one earring. Repeat all instructions to make the second earring. You will also need a toothpick or scrap of wire for this project.
- Using a toothpick or scrap of wire place a dab of glue into the pendant setting and place one 14mm lime rivoli into the setting. Set aside and allow to dry.
- Place a dab of glue, into two of the link settings. Place one 12mm lime rivoli into each link. Set aside and allow to dry.
- Allow the settings to dry for at least 15 minutes before continuing.
- Next, open one jump ring and attach it to the pendant setting and to one lime link. Close the jump ring.
- Open another jump ring and attach it to the link you just added and to the other lime link. Close the jump ring.
- Open one more jump ring to attach the earring post to the last lime link that you added. Close the jump ring.
WHAT YOU'LL NEED: (scroll down for purchase options)
- SWCR-4447 - Austrian Crystal, 1122 Rivoli Fancy Stones 14mm, 2 Pieces, Crystal Lime
Project uses 2 pieces. You will need 1 package.
- SWCR-4443 - Austrian Crystal, 1122 Rivoli Fancy Stones 12mm, 4 Pieces, Crystal Lime
Project uses 4 pieces. You will need 1 package.
- PND-5693 - TierraCast 22K Gold Plated Pewter Faceted Pendant Setting For 14mm Rivoli (2)
Project uses 2 pieces. You will need 1 package.
- FCO-9430 - TierraCast Faceted Connector Setting, Fits 12mm Austrian crystal Rivoli, 22K Gold Plated
Project uses 4 pieces. You will need 4 packages.
- FEA-1526 - TierraCast 22K Gold Plated Pewter Stud Post Earrings Hammered 13.5mm 1 Pair
Project uses 1 Pair. You will need 1 package.
- FEA-1017 - Bullet Clutch Earring Backs, Hypo Allergenic with Pad 7x11mm, 50 Pieces, Gold Tone
Project uses 2 pieces. You will need 1 package.
- FJR-5250 - 22K Gold Plated Open Jump Rings 5mm 20 Gauge (100)
Project uses 6 pieces. You will need 1 package.
- XTL-1054 - E6000 Industrial Strength Glue Adhesive (0.18 fl oz)
Project uses 1 piece. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
- XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers