Retired - Lilac Dreamer Earrings

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Lay the Vintaj Vogue pendant with the patterned side up onto your work surface.
2. Shake the Vintaj Patina bottle to mix the paint. Pour a little bit on to a work surface. Take your paint brush and paint the front of the pendant, making sure the paint gets into the grooves of the pendant.
3. Quickly wipe off the paint with a dry paper towel. If you need to do a second coat do so now. Repeat and wipe off the pendant.
4. Using the Vintaj metal relief block, buff lightly over the top of the pendant, revealing the leaf pattern.
5. Use the Vintaj Metal sealant over the top and bottom of the pendant. Allow it to dry completely.
6. Open one jump ring and attach it to the pendant and to one more jump ring. Close the jump ring.
7. Open the loop of the earring finding and attach it to the second jump ring. Close the loop.
8. All done!

• FEA-6621 - Vintaj Vogue Earring Components, French Ear Wire 20x10mm, 6 Pieces, Raw Brass
  Project uses 2 pieces. You will need 1 package.


• FJR-07007 - Jump Rings, Open 5mm Diameter 20 Gauge, 100 Pieces, Raw Brass
  Project uses 4 pieces. You will need 1 package.


• PND-2232 - Vintaj Vogue Pendants, Patterned Leaf 35x22mm, 1 Piece, Raw Brass
  Project uses 2 pieces. You will need 2 packages.


• XTL-1133 - Vintaj Patina, Opaque Permanent Ink For Metal, 0.5 Ounce, Chalcedony
  Project uses 1 piece. You will need 1 package.


• XTL-9090 - Vintaj Mini Glaze - Metal Sealer And Patina Extender - 0.5 Ounce Bottle
  Project uses 2 pieces. You will need 1 package.

• XTL-2222 - Vintaj Metal Relief Block For Filing, Buffing & Sanding
• XTL-5511 - The Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
• XTL-5514 - The Beadsmith Jewelry Fine Round Nose Micro Pliers