Retired - Let's Do Brunch Earrings

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Begin by cutting two pieces of chain. One 1 inch long and the other 1/2 inch long. Set aside.
2. Thread one bacon bead onto one head pin. Make a simple wire loop. Set aside.
3. Thread one egg bead onto one head pin. Make a simple wire loop. Set aside.
4. Attach the simple wire loop of the bacon bead to one end of the 1 inch chain, the same as you would a jump ring. Close the wire loop.
5. Attach the simple wire loop of the egg bead to one end of the 1/2 inch chain, the same as you would a jump ring. Close the wire loop.
6. Open the loop of the earring hook and attach both chain ends to this loop. Close the loop.

• BWC-3068 - Hand Painted Ceramic Beads - Small Sunny Side Up Egg Double Sided 13x11mm - Pack of 2
  Project uses 2 pieces. You will need 1 package.


• BWC-3089 - Hand Painted Ceramic Beads - Small Bacon Strips 16.5x9mm - Pack of 2
  Project uses 2 pieces. You will need 1 package.


• FHP-3020 - 22K Gold Plated 2mm Ball Head Pins 21 Gauge 1.5 Inch (20)
  Project uses 4 pieces. You will need 1 package.


• FEA-3020 - 22K Gold Plated Fish Hook Earring Hooks (50)
  Project uses 2 pieces. You will need 1 package.


• CHA-99958 - 22K Gold Plated Slim Rolo Chain 2mm Bulk By The Foot
  Project uses 3 inches. You will need 1 package.

• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex
• XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers
• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose