Retired - Keepsake Glass Vial Necklace with Flower

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. To see how to make the flower, check out this video here. Use your 26 gauge silver colored wire (10 - 12 inches), Toho 11/0 beads in transparent luster rose, Czech 11/0 seed beads mix lot in greens, and finally for the center of the flower, an Austrian crystal flat back crystal rhinestone in sunflower. Follow the video and make the flower according to the step by step instructions. Insert the flower into your glass bottle following the video directions.
2. Once your flower is in the bottle, scoop some extra green seed beads into the base so that it forms a "bed" for your flower to rest on. Shake these to the bottom.
3. Screw the lid onto your bottle tightly.
4. Take your 3 feet of chain and on one of the ends, remove the last link. Open the link just the same as you would a jump ring. Now divide your chain in half (just fold in half) and find the middle link. Onto that middle link attach the link you removed from the end and connect it to the hoop at the top of your glass vial pendant. Close the link back up like a jump ring.
5. Now go to one end of your chain and open that end link like a jump ring. Attach onto it the loop at the base of your key toggle bar. Close your loop back up the same way you would close a jump ring. Go to the other side of your necklace and attach the round part of the clasp the same way.

• SWF-112999 -
  Project uses 1 piece. You will need 1 package.


• CHA-9806 - Nunn Design Antiqued Gold Plated Textured Cable Chain By The Foot
  Project uses 3 feet. You will need 3 packages.


• JSK-0091 - Toho Round Seed Beads 11/0 290 'Transparent Lustered Rose' 8 Gram Tube
  Project uses 24 pieces. You will need 1 package.


• BCS-1690 - Czech Seed Beads 11/0 Mix Lot Irish Green Emerald
  Project uses 24 pieces. You will need 1 package.


• PND-6801 - Nunn Design Antiqued Gold Plated Pewter/Glass Keepsake Pendant
  Project uses 1 piece. You will need 1 package.


• FCL-7206 - Nunn Design Antiqued 24kt Gold Plated Key Toggle Clasp Bar 24mm
  Project uses 1 piece. You will need 1 package.


• FCL-7510 - Nunn Design Antiqued Gold 24kt Plated Round Toggle Clasp Ring 18.5mm (1)
  Project uses 1 piece. You will need 1 package.


• WNT-2630 - Beadsmith Tarnish Resistant Silver Color Copper Wire 26 Gauge 34 Yards (31 Meters)
  Project uses 10-12 inches. You will need 1 package.


• XTL-1054 - E6000 Industrial Strength Glue Adhesive (0.18 fl oz)
  Project uses 1 piece. You will need 1 package.

• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex